Hyundai Elantra: ABS(Anti-Lock Brake System) / ABS Control Module Components and Components Location
| Components |
| 1. Front - right tube 2. Rear - left tube 3. Rear - right tube 4. Front - left tube | 5. MC SEC 6. MC PRI 7. ABS control module(HECU) 8. Bracket |
Troubleshooting
Standard Flow of Diagnostic Troubleshooting
Notes With Regard To Diagnosis
The phenomena listed in the following table are not abnormal.
ConditionExplanationSystem check soundWhen starting the en ...
ABS Control Module Repair procedures
Removal
1.
Turn the ignition switch OFF and then disconnect the negative (-) battery cable.
2.
Pull up the lock of the HECU connector (A) , then disconnect the connector.
3.
Remove the bra ...
Other information:
Hyundai Elantra AD (2016-2020) Service Manual: ETC (Electronic Throttle Control) System Repair procedures
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T.
Throttle AngleOutput Voltage (V)TPS 1TPS 2C.T0.54.5W.O.T4.410.59
ETC Motor
1.
Turn the ignition ...
Hyundai Elantra AD (2016-2020) Service Manual: Oil Pressure Switch Repair procedures
Removal and Installation
1.
Disconnect the oil pressure switch connector (A) and then remove the oil pressure switch (B).
Tightening torque :
9.8 ~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)
2.
Install in the reverse order of removal.
•
When installing the o ...
