Inspection |
1. |
Connect the GDS on the Data Link Connector (DLC). |
2. |
Turn the ignition switch ON. |
3. |
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.
|
Hyundai Elantra AD (2016-2020) Service Manual: Transaxle Control Module (TCM) Repair procedures
Inspection
Transaxle Control Module(TCM) Problem Inspection Procedure
1.
TEST TCM GROUND CIRCUIT: Measure resistance between TCM and
chassis ground using the backside of TCM harness connector as TCM side
check point. If the problem is found, repair it.
Specification: Below 1?
2.
TE ...
Hyundai Elantra AD (2016-2020) Service Manual: Knee Airbag (KAB) Module Description and Operation
Description
The Knee Airbag (KAB) is installed inside the crash pad lower
panel and protects the driver in the event of a frontal crash. The
SRSCM determines if and when to deploy the KAB.
•
Never attempt to measure the circuit resistance of the airbag
module (sq ...