Hyundai Elantra: Ignition System / Description and Operation
Hyundai Elantra AD (2016-2020) Service Manual / Engine Electrical System / Ignition System / Description and Operation
| Description |
Ignition timing is controlled by the electronic control ignition timing system.
The standard reference ignition timing data for the engine
operating conditions are pre-pro grammed in the memory of the ECM
(Engine Control Module).
The engine operating conditions (speed, load, warm-up
condition, etc.) are detected by the various sensors. Based on these
sensor signals and the ignition timing data, signals to interrupt the
primary current are sent to the ECM.
The ignition coil is activated, and timing is controlled.
Ignition System
...
Repair procedures
On-vehicle Inspection
Inspect ignition coil assembly and Perform spark test
1.
Check for DTCs.
•
If a DTC is present, perform troubleshooting in accordance with the ...
Other information:
Hyundai Elantra AD (2016-2020) Owners Manual: Floor Mat Anchor(s)
ALWAYS use the Floor Mat Anchors to attach the front floor mats to the vehicle.
The anchors on the front floor carpet keep the floor mats from sliding forward.
WARNING
The following must be observed when installing ANY floor mat to the vehicle.
Ensure to remove a protective film attached o ...
Hyundai Elantra AD (2016-2020) Service Manual: Troubleshooting
Failure Diagnosis
1.
In principle, ESC and TCS controls are prohibited in case of ABS failure.
2.
When ESC or TCS fails, only the failed system control is prohibited.
3.
However, when the solenoid valve relay should be turned off in case of ESC failure, refer to the ABS fail-safe.
4.
...
© 2018-2025 www.helantraad.com
