Hyundai Elantra: Body Side Molding / Front Mud Guard Repair procedures

Replacement
   
Put on gloves to prevent hand injuries.
   
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
Take care not to scratch the body surface.
1.
After loosening the mounting screws and remove the front mud guard (A).

2.
To intall, reverse the removal procedure.
   
Replace any damaged clips (or pin-type retainers).
Rear Wheel Guard Repair procedures
Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape around ...

Rear Mud Guard Repair procedures
Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape around ...

Other information:

Hyundai Elantra AD (2016-2020) Owners Manual: Seat Belt Restraint System
Seat Belt-Driver's 3-point system with emergency locking retractor To fasten your seat belt: Pull the seat belt out of the retractor and insert the metal tab (1) into the buckle (2). There will be an audible "click" when the tab locks into the buckle. You should place the lap ...

Hyundai Elantra AD (2016-2020) Service Manual: Parking Brake Switch Repair procedures
Removal 1. Disconnect the negative (-) battery cable. 2. Release the parking brake. 3. Remove the floor console assembly. (Refer to Body - "Floor console") 4. Disconnect the connector (A) of parking brake switch. 5. Loosen the screw and then remove the parking brake switch. ...

© 2018-2025 www.helantraad.com