Hyundai Elantra: Automatic Transaxle Control System / Inhibitor Switch Specifications
| Specifications |
| Items | Specifications |
| Power supply (V) | 12 |
| Output type | Combination of output signals |
Inhibitor Switch Description and Operation
Description
•
The inhibitor switch mounted on the upper of transaxle and connected with shifter lever.
•
The inhibitor switch has four points of contact and it makes the signals(S1, S ...
Inhibitor Switch Schematic Diagrams
Circuit Diagram
...
Other information:
Hyundai Elantra AD (2016-2020) Owners Manual: Detecting Sensor. Warning message
The rear radars are located inside the rear bumper for detecting the side and
rear areas. Always keep the rear bumper clean for proper operation of the system.
NOTICE
The system may not work properly when the bumper has been damaged, or
if the rear bumper has been replaced or repaired.
...
Hyundai Elantra AD (2016-2020) Service Manual: Torque Converter Control Solenoid Valve (T/CON_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
3.
Disconnect the solenoid valve connector (A).
4.
Measure resistance between sensor signal terminal and sensor ground terminal.
5.
Check that the ...
