Hyundai Elantra: Rear Door / Rear Door Belt Outside Weatherstrip Repair procedures
| Replacement |
| 1. |
Pull down the rear door window glass to the lowest level by pressing the power window glass switch. |
| 2. |
After loosening the mounting screws, remove the rear door belt outside weatherstrip (A).
|
| 3. |
To intall, reverse the removal procedure.
|
Rear Door Latch Repair procedures
Replacement
1.
Remove the rear door module.
(Refer to Rear Door - "Rear Door Module")
2.
Remove the rear door inside handle cage (A).
3.
Disconnect the rear door latch connector (A).
4 ...
Rear Door Belt Inside Weatherstrip Repair procedures
Replacement
1.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
2.
Remove the rear door belt inside weatherstrip (A).
3.
To intall, reverse the removal procedure.
...
Other information:
Hyundai Elantra AD (2016-2020) Owners Manual: Electronic Power Steering (EPS) Warning Light, Malfunction Indicator Lamp (MIL)
Electronic Power Steering (EPS) Warning Light
This warning light illuminates:
Once you turn the ignition switch or the Engine Start/Stop button to the
ON position.
- It illuminates for approximately 3 seconds and then goes off.
When there is a malfunction with the EPS.
In this case, ...
Hyundai Elantra AD (2016-2020) Service Manual: Start/Stop Button Repair procedures
Removal
1.
Disconnect the negative(-) battery terminal.
2.
Remove the crash ped lower panel.
(Refer to Body - "Crash Ped Lower Panel")
3.
Remove the start/stop button (B) after disconnect the connector (A).
Installation
1.
Install the start/stop button.
2.
Install the crash pa ...
