Hyundai Elantra: Cowl Top Cover / Repair procedures

Replacement
1.
Remove the plug hole.

2.
Loosen the mounting nuts and remove the wiper arm (A).

Tightening torque :
22.6 ~ 26.5 N.m (2.3 ~ 2.7 kgf.m, 16.6 ~ 19.5 lb-ft)

3.
Using a screwdriver or remover, remove the cowl side cover (A).

4.
Disconnect the washer nozzle (A).
5.
Detach the clips, then remove the cowl top cover (B).

6.
To intall, reverse the removal procedure.
   
Replace any damaged clips (or pin-type retainers).
Components and Components Location
Component Location 1. Cowl top cover ...

Floor Console
...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Description and Operation
Description TREAD Lamp - Tire Under Inflation / Leak Warning. 1. Turn on condition A. When tire pressure is below allowed threshold B. When rapid leak is detected by the sensor. C. Indicates that tire needs to be re-inflated to placard pressure / repaired. 2. Turn off condi ...

Hyundai Elantra AD (2016-2020) Service Manual: Troubleshooting
Basic Troubleshooting Basic Troubleshooting Guide Customer Problem Analysis Sheet Basic Inspection Procedure Measuring Condition of Electronic Parts' Resistance The measured resistance at high temperature after vehicle running may be high or low. So all resistance must be measured at ambi ...

© 2018-2024 www.helantraad.com