Hyundai Elantra: Brake System / Vacuum Pump Repair procedures

Removal
1.
Remove the cylinder head cover.
(Refer to Cylinder Head Assembly - "Cylinder Head Cover")
2.
Remove the timing chain.
(Refer to Timing System - "Timing Chain")
3.
Remove the vacuum pump (A).

   
Do not disassemble the vacuum pump.
4.
To install, reverse the removal procedure.
Vacuum Pump Components and Components Location
Components [UII 1.6] 1. Camshaft bearing cap2. Camshaft3. Camshaft sprocket4. Vacuum pump5. Vacuum pump gasket ...

Master Cylinder Components and Components Location
Components 1.Reservoir cap2. Reservoir3.Reservoir4. Grommet5. Master cylinder ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Alternator Schematic Diagrams
Circuit Diagram     • COM signal - When controlling the voltage generated, the ECM sends the target voltage data to the alternator via a PWM signal.(High voltage: 4V or higher, low voltage: 2V or lower) • FR signal - The transistor activation signal inside t ...

Hyundai Elantra AD (2016-2020) Service Manual: ETC (Electronic Throttle Control) System Repair procedures
Inspection Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T. Throttle AngleOutput Voltage (V)TPS 1TPS 2C.T0.54.5W.O.T4.410.59 ETC Motor 1. Turn the ignition ...

© 2018-2025 www.helantraad.com