Hyundai Elantra: Restraint / Airbag Module
- Driver Airbag (DAB) Module and Clock Spring Components and Components Location
- Driver Airbag (DAB) Module and Clock Spring Description and Operation
- Driver Airbag (DAB) Module and Clock Spring Repair procedures
- Passenger Airbag (PAB) Module Components and Components Location
- Passenger Airbag (PAB) Module Description and Operation
- Passenger Airbag (PAB) Module Repair procedures
- Side Airbag (SAB) Module Components and Components Location
- Side Airbag (SAB) Module Description and Operation
- Side Airbag (SAB) Module Repair procedures
- Curtain Airbag (CAB) Module Components and Components Location
- Curtain Airbag (CAB) Module Description and Operation
- Curtain Airbag (CAB) Module Repair procedures
- Knee Airbag (KAB) Module Components and Components Location
- Knee Airbag (KAB) Module Description and Operation
- Knee Airbag (KAB) Module Repair procedures
- Airbag Module Disposal Description and Operation
Occupant Classification System (OCS) Repair procedures
Removal
Occupant Classification System (OCS) Unit
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the front passenger seat assem ...
Driver Airbag (DAB) Module and Clock Spring Components and Components Location
Components
1. Driver Air Bag (DAB)2. Steering Wheel3. Clock Spring
...
Other information:
Hyundai Elantra AD (2016-2020) Owners Manual: Detecting Sensor. Warning message
The rear radars are located inside the rear bumper for detecting the side and
rear areas. Always keep the rear bumper clean for proper operation of the system.
NOTICE
The system may not work properly when the bumper has been damaged, or
if the rear bumper has been replaced or repaired.
...
Hyundai Elantra AD (2016-2020) Service Manual: Overhead Console Lamp Repair procedures
Inspection
1.
Remove the overhead console lamp assembly then check for
continuity between terminals. If the continuity is not as specified,
replace the map lamp switch.
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the mounting screws (2EA).
And then remove the ...
