Hyundai Elantra: Audio / Audio Unit Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the center fascia panal.
(Refer to Body - "Center Fascia Panal")
3.
Remove the audio head unit (A) after loosening the screws.

4.
Remove the audio head unit after disconnecting the connectors and cable (A).

   
When the compact disc is not ejected, do not remove it forcibly.
Installation
1.
Connect the audio unit connectors and cable.
2.
Install the audio head unit.
3.
Install the center fascia panal.
4.
Connect the negative (-) battery terminal.
   
A.
Make sure the connector are connected in properly.
B.
Check the audio system.
Audio Unit Components and Components Location
Components [TFT Type] Connector Pin Information NoConnector AConnector BConnector C1Rear left speaker (+)Can (High)- 2Front left speaker (+)-- 3Front right speaker (+)-Camera GND 4 ...

Speakers Repair procedures
Inspection 1. Troubleshooting for Speaker (1) Basic inspection of speaker Inspect the sound from speaker after verifying that the speaker mounting screws is removed and the wiring connector i ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: License Lamps Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the trunk lid panel. (Refer to Body - "Trunk Lid Trim") 3. Remove the license lamp (A) after disengaging the license lamp mounting clip (B). 4. Replace the bulb (A) after removing a lens. Installation 1. Install ...

Hyundai Elantra AD (2016-2020) Service Manual: Rear Wheel Guard Repair procedures
Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • Take care not to scratch the body surface. ...

© 2018-2024 www.helantraad.com