Hyundai Elantra: Back View Camera System / Description and Operation

Description
Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position.
This system is a supplemental system that shows behind the vehicle through the AV monitor while backing-up.
   
This system is a supplementary function only. It is the responsibility of the driver or always check the inside/ outside rearview mirror and the area behind the vehicle before and while backing up because there is a dead zone that can't see through the camera.
Schematic Diagrams
Circuit Diagram ...

Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the trunk lide trim. (Refer to Body - "Trunk Lid Trim") 3. Disconnect the back view camera connector. 4. Remove the ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Fuel Tank Air Filter Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the battery negative (-) terminal. 2. Remove the canister assembly. (Refer to Emission Control System - "Canister") 3. Remove the installation bolt (A), and then remove the air filter (B). 4. Release the lever (A), and then separa ...

Hyundai Elantra AD (2016-2020) Service Manual: Stop Lamp Switch Schematic Diagrams
Schematic Diagram System circuit diagram Terminal function TeminalDescription1IGN12Engine Control Module (ECM)3B+4Stop Lmap ...

© 2018-2025 www.helantraad.com