Hyundai Elantra: Anti-lock Brake System (ABS) Warning Light, Electronic Brake Force Distribution (EBD) System Warning Light / Master, Door Ajar, Trunk Open, Hood Open Warning Lights Light
Master Warning Light
This indicator light illuminates
• When there is a malfunction in operation in any of the following systems:
- Exterior lamp malfunction
- Blind-Spot Collision Warning (BCW) malfunction (if equipped)
- Lane Keeping Assist (LKA) System malfunction (if equipped)
- Tire Pressure Monitoring System (TPMS)
- Service reminder
To identify the details of the warning, look at the LCD display.
Door Ajar Warning Light (for conventional cluster)
This warning light illuminates:
• When a door is not closed securely.
Trunk Open Warning Light (for conventional cluster)
This warning light illuminates:
• When the trunk is not closed securely.
Hood Open Warning Light (for conventional cluster)
This warning light illuminates:
• When the hood is not closed securely.
Headlight Warning Light, LED Headlight Warning Light
Headlight Warning Light
This warning light illuminates:
This warning light illuminates if one of the exterior bulbs (headlamp, DRL, turn
signal lamp, stop lamp, etc.) is not operating properly. ...
Icy Road Warning Light, Electronic Stability Control (ESC) Indicator Light
Icy Road Warning Light
This warning light is to warn the driver the road may be icy.
When the temperature on the outside temperature gauge is approximately below
40°F (4°C), the Icy Road Warni ...
Other information:
Hyundai Elantra AD (2016-2020) Service Manual: Immobilizer Control Unit Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the main crash pad assembly.
(Refer to Body - "Main Crash Pad Assembly")
3.
Discnnect the connector of the immobilizer unit and then remove the immobilizer unit (A) after loosening a nut.
Installation
1.
Install the ...
Hyundai Elantra AD (2016-2020) Service Manual: PTC Heater Repair procedures
Inspection
Operating Logic Test (Manual only)
Inspect the PTC operation by confirmation logic as follows.
1.
Entering
(1)
Set the Floor mode and maximum heating position.
(2)
Turn off the blower switch.
(3)
Press the intake (recirculation) button 5 times or more.
(4)
\Indicators ...
