Hyundai Elantra: General Information / Troubleshooting

Hyundai Elantra AD (2016-2020) Service Manual / Heating, Ventilation and Air Conditioning / General Information / Troubleshooting

Troubleshooting

Problem Symptoms Table

Before replacing or repairing air conditioning components, first determine if the malfunction is due to the refrigerant charge, air flow or compressor.

Use the table below to help you find the cause of the problem. The numbers indicate the priority of the likely cause of the problem. Check each part in order. If necessary, replace these parts.

After correcting the malfunction, check the complete system to ensure that performance is satisfactory.

Standard:

Symptom	Suspected Area
No blower operation	Blower fuse
	Blower relay
	Blower motor
	Power mosfet
	Blower speed control switch
	Wire harness
No air temperature control	Engine coolant capacity
No air temperature control	Heater control assembly
No compressor operation	Refrigerant capacity
	A/C fuse
	Compressor
	A/C pressure transducer
	A/C switch
	Evaporator temperature sensor
	Wire harness
Vented air not cold	Refrigerant capacity
	Refrigerant pressure
	Drive belt
	Compressor
	A/C pressure transducer
	Evaporator temperature sensor
	A/C switch
	Heater control assembly
	Wire harness
Insufficient cooling	Refrigerant capacity
	Drive belt
	Compressor
	Condenser
	Expansion valve
	Evaporator
	Refrigerant lines
	A/C pressure transducer
	Heater control assembly
No engine idle-up when A/C switch ON	Engine ECM
No engine idle-up when A/C switch ON	Wire harness
No air inlet control	Heater control assembly
No mode control	Heater control assembly
No mode control	Mode actuator
No cooling fan operation	Cooling fan fuse
	Fan motor
	Engine ECM
	Wire harness

Specifications

Specification Air Conditioner ItemSpecificationCompressorType6VSe14Oil type & CapacityFD46XG (IDEMITSU) 110 ± 10 g (3.88 ± 0.35 oz.)Pulley type6PK-TYPEDisplacement142 cc/revExpansion valveTy ...

Special Service Tools

Special Service Tools Tool (Number and name)IllustrationUse09977-3R000Disc & hub assembly bolt removerRemoval and installation of disc & hub assembly. ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Front Strut Assembly Repair procedures
Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from front hub. Tightening torque : 107.9 ~ 127.5 N.m (11.0 ~ 13.0 kgf.m, 79.6 ~ 94.0 lb-ft) • Be careful not to dam ...

Hyundai Elantra AD (2016-2020) Owners Manual: Checking the tire inflation pressure
1. After driving approximately 7~10 km (4~6 miles or about 10 min), stop at a safety location. 2. Connect the filling hose (3) directly into the compressor 3. Connect the other end of the filling hose (3) directly into the valve. 4. Plug the compressor power cord into the vehicle power outl ...