Hyundai Elantra: Engine Mechanical System / Cylinder Block
- Components and Components Location
- Drive plate Components and Components Location
- Drive plate Repair procedures
- Rear Oil Seal Components and Components Location
- Rear Oil Seal Repair procedures
- Piston and Connecting Rod Components and Components Location
- Piston and Connecting Rod Repair procedures
- Crankshaft Components and Components Location
- Crankshaft Repair procedures
- Cylinder Block Repair procedures
Cylinder Head Repair procedures
Removal
Engine removal is not required for this procedure.
•
Use fender covers to avoid damaging painted surfaces.
•
To avoid damaging the cylinder head, wait un ...
Components and Components Location
Components
1. Piston ring2. Snap ring3. Piston pin4. Piston5. Connecting rod 6. Connecting rod upper bearing7. Connecting rod lower bearing8. Conne ...
Other information:
Hyundai Elantra AD (2016-2020) Service Manual: General Information
Specifications
Specification
Air Conditioner
ItemSpecificationCompressorType6VSe14Oil type & CapacityFD46XG (IDEMITSU) 110 ± 10 g (3.88 ± 0.35 oz.)Pulley type6PK-TYPEDisplacement142 cc/revExpansion valveTypeBlock typeRefrigerantTypeR-134aCapacity500 ± 25 g (17.6 ± 0.88 oz.)
Blower Un ...
Hyundai Elantra AD (2016-2020) Service Manual: Knock Sensor (KS) Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the knock sensor connector (A).
3.
Remove the intake manifold.
(Refer to Engine Mechanical System - "Intake Manifold")
4.
Remove the installation bolt (A), and then remove the sens ...
